Installing Stainless Steel Bar Holder

 Download PDF Instructions

Overview
Below are instructions for mounting a Bar Holder of our Bar system. The bar holders are made to fit our Stainless Steel Square Bars.

Caution: Wear protective ANSI approved safety glasses, working gloves and breathing mask at all times

 

 

 

 

 


Tools Required

 2.5mm allen wrenchpage1image6320


page1image6480 

Components:

1)  Bar holder

2)  4 x M5 screws

3)  Mounting ring

 

 

 

 

 

 

 

 

 


Instructions

1) Unscrew the two side M5 screws until the mounting ring falls out

page2image3432  

2)  Connect the mounting ring to the post surface using an M6 x 1.0mm (or equivalent) countersunk screw [Inline Design provides M6 screws when purchasing a post kit]

3)  Slide the bar holder over the ring then fasten the two side M5 screws. Please note that in case of stairs installation rotate the bar holder at the desired angle of the stairs

Note: For illustration purpose the figure is showing the screws as being on top. In real scenarios you want the screws to be at the bottom so they don’t show

4)  The bar holder is designed with two screws so it can accommodate two bars from either side like a joiner

5)  Refer to these instructions to install Inline Design square or round tubing and additional hardware

Note: If using a round handrail, position the round saddle adapter on top of the flat saddle before attaching handrails


NOTE: A small amount of surface corrosion is not uncommon after some exposure to weather or salty conditions; we recommend using our passivation solution or a stainless steel polish to prevent surface corrosion